Step-by-step instructions for gluing inner corners
After completing, the principal problem can be irregular walls as well as the resulting folds on the background. It is also essential to take into account that if the walls are twisted the joints of background canvases may diverge.
After gluing the last one in the front of the interior corner of the fabric must measure the remaining space. It is measured from the border of the pasted cloth to the adjacent wall, and the resulting figure is added 10-15 millimeters. When the walls are extremely curved, then the extra figure could be more.
Cut a strip equal to the resultant figure, taking into account the allowance. The surfaces are treated with adhesive. Based on the kind of coating it could be just the wall or the surfaces.
The strip is then glued individually using the cut side into the wallsocket. The background should go on the other plane.
In case the glued wallpaper is sterile, then you will need to make a few modest cuts perpendicular to the springs.
Level or incline on the adjacent wall is a perpendicular lineup. The distance in the corner is equal to the width of the prior cut strip, never including developments.
The surfaces are smeared with glue, and then the coating is glued to the wall using the flat side to the marked line. The cut side goes on the adjoining wall.
Protruding corner ought to be pasted by analogy using an inner, but there are little gaps, which also have to be taken into account when working.
Measured the space remaining in the glued background into the adjoining wall. gidpola.ru Add 20-25 millimeters to the captured figure.
A section is cut off, considering the added 20-25 millimeters.
Before gluing, the surfaces are treated with adhesive.
The edge has to be glued into the wallpaper fixed on the walls, your own cut side”extends” into the adjacent plane. If necessary, small cuts are created in the place of visiting the other wallpaper, smoothed and pressed to the wallsocket.
Draw a vertical strip onto the adjoining wall at a distance of only glued cut strip and 6-10 millimeters.
After applying the glue, the strip is applied to the wall using its flat side into the line, moving over the border of the glued strip.
The joints are smeared with glue and ironed with a rollercoaster. After that, the upper layer is trimmed along the ruler and the 2 layers are joined together.