A corner apartment is located in the end of the construction: that is, a part of its walls aren’t adjacent to the neighbors, but will be the outer walls of the home.
There may be one flat in a corner flat – it occupies the entire end of the house, it is likewise referred to as a corner apartment. Or two – that the windows of a forget the street, the next domikday.ru – the lawn. Is based on the building plan, the design of the assumptions.
There is also a”separate caste” – casing with walls in the expansion joints. Such”gaps” between entrances are normally made in multi-story buildings, the most important undertaking of the unit – to break the deformation forces throughout the shrinkage of the construction, in the event of crises. Pros and cons of both corner flats in the joint are slightly different from the typical ones with access to this road – we’ll pay particular attention to the topic in the previous section.
Considering that the 2-3 sides of the space is outside, in winter it is 3-5C colder, and in summer on the opposite – sexier. Particularly if the conclusion of the home is heated by sunlight. In some cases, the gap reaches 10C – however such a distinction is unacceptable, indicates that a problem with the exterior of the house – most likely have to speak to the management company, asking (or forcing) to meet their direct duties, to patch the cracks formed.
Corner flat in a brick house with thick walls is more comfy. Such risks are not subjected – the thickness of the wall acts as a buffer, not allowing overheating, overcooling.
When an area has just one wall united with the street, it generally has enough room heat to prevent freezing and warmth. However, when there are two outdoor partitions, and they’re adjacent – there’s a higher probability of freezing in the corner, the creation of condensation in it, and therefore – mould, fungus. Their spores not only spoil the overall look of the space, but also lead to the appearance, complication of many serious diseases.
Important! The problems of corner location are compounded when the factors are linked – too low temperatures from heating batteries combined with dampness is guaranteed to lead to moldy walls.